Pre-Service

  1. Make sure the audio system for sound is on including the FOH console (Sound board)
  2. On the tracks rig, turn off the entire system by click the red button in the bottom right
  3. Wait about 10 seconds and turn it back on. This restarts the entire system!
  4. Open Macbook computer on the Tracks rig, If already on, go to step 6
  5. Password: cleaning1
  6. Go ahead and restart the whole computer. This will make sure we have everything working the way it should
  7. When prompted, put in the password for the computer again: cleaning1
  8. Open the Playback app on the Macbook
  9. Click on the button right to the right of edit and then choose Open Setlist
  10. Open the setlist for the specific service you need and then click “Load”

Here is a video demonstration:

Playback Load.mov

  1. If for some reason you don’t get all the outputs for all the specific buses, 1st make sure the FOH audio console is fully up and operational then restart the Playback computer.

  2. If you still don’t get audio, go into the settings icon in the top right corner of Playback and under the General tab, make sure the audio output says CCW Worship (This will be rare that it doesnt say this)

  3. Next setup Playback Remote. In the top right corner of the Playback computer (Host is the main computer) click on the 3 lines and choose

    IMG_0743 copy.jpg

  4. Then click on Host and turn the button on for the Host computer to allow remote connections (it will turn blue)

    IMG_0744 copy.jpg

  5. Grab the iPad that charges next to the mic stations in the Green room and unlock using the code 0812.

  6. Under the CCW tab click on Playback and then click the 3 dots in the top right corner and choose Playback remote again.

  7. Next click on “Remote” and choose the CCW Worship. It should sync up BUT if it doesn’t, go back on the host computer and click on the red dot icon in the top right corner and choose “Save to Cloud” and then the remote ipad will work